Description

Hino Truck 2017 COE HEV Service Manual

This is the Repair and Service Manual for Hino Truck 2017 COE HEV
Applicable for HINO 155, 155h, 195, 195h series,
Format: PDF
Language: English

Hino 2017 COE HEV Truck Manual for 155, 155h, 195, 195h Series – 842 Pages
Hino 2017 Owners Manual – 354 Pages
Troubleshooting Manual for Hino 2017 COE HEV – 860 Pages
Hino J05E Engine Manual – 648 Pages

This workshop manual has been prepared to provide information covering repairs on 155, 155h, 195, 195h Series Hino 2017 COE HEV trucks.

To use Hino Year 2017 and Series 155, 155h, 195, 195h Conventional trucks for years, smoothly, safely, and economically without trouble, it is important to perform inspections.
Maintenance required to be performed is the responsibility of the owner. Some recommended repairs of your truck are mentioned. When making any repair of your truck, be careful not to be injured through improper procedures.

As for maintenance items, refer to the Owners and Drivers Manual. All information and specifications in this manual are based upon the latest product information available at the time of printing.

Table of Content For Hino 2017 COE HEV Truck Manual:

General Introduction
Engine
Hybrid System
Transmission
Clutch
Propeller Shaft
Axle
Differential
Brake
Steering
Frame and Frame Accessory
Cab Mounting and Cab Suspension
Body Construction
Suspension
Body Inside Accessory
Body Outside Accessory
Air Bag and Seat Belt
Heater and Air Conditioner
Electrical
Control System

Hino Truck 2017 COE HEV Manual Instruction Extract:

INSPECTING THE SHOCK ABSORBER
1. INSPECTING THE SHOCK ABSORBER
(1) Elongate and contract the shock absorber to inspect for abnormal noise and oil leakage. Make sure the operating load of its stroke is constant in all the range and there is no abnormal interference.
NOTICE
Press down the shock absorber to the lowest end, then it is left to stretch to its highest position by itself. Repeat the motion 4 or more times.
INSTALLING THE SHOCK ABSORBER
1. MOUNTING THE SHOCK ABSORBER BUSHING (1) Mount the new shock absorber bushing to the shock absorber by using the SST and the press.
SST: 09222-64012
Connecting rod bushing remover & replacer 09726-10011
Lower suspension arm bushing remover & replacer
2. INSTALLING THE SHOCK ABSORBER
(1) Use the bolt to temporary mount the shock absorber upper side to the frame via the cushion No.1 (2 pcs.).
(2) Use the bolt to temporary mount the shock absorber lower side via the cushion No.1 (2 pcs.).
(3) Fully tighten the both side bolts (2 pcs.).
Tightening Torque:
68 Nm {693 kgfcm, 50 lbfft}