Challenger MT455E, MT465E, MT475E Tractor Service Manual
$40.00
Challenger MT455E, MT465E, MT475E Tractor Workshop Manual : 1376 Pages
Technician Service Book MT400E (Schematics and Electronics) : 646 Pages
Spicer Dana 740, 735 Axle Service Manual: 176 Pages & 176 Pages
- Description
- Reviews (0)
Description
Challenger MT455E, MT465E, MT475E Tractor Repair Workshop Manual
Manual for: AGCO Challenger MT400E Series Tractor
Format: PDF
Book Number: ACT0026660
English
Issued May 2016
Challenger MT455E, MT465E, MT475E Tractor Workshop Manual : 1376 Pages
Technician Service Book MT400E (Schematics and Electronics) : 646 Pages
Spicer Dana 740, 735 Axle Service Manual: 176 Pages & 176 Pages
Challenger MT400E Series Manual TABLE OF CONTENTS
- Introduction
- Separation of assemblies
- Engine
- Clutch
- Gearbox
- Rear Axle
- Power Take off
- Front Axle
- Hydraulics
- Electricity
- Electronics
- Operator Environment
- Accessories
- Services Tools
MT455E, MT465E, MT475E Manual Error Code
Err 14 | See error message 17/18 |
Err 15 | The maximum front or rear transmission ratio has not been reached. |
Repeat | Repeat calibration. |
If nec | If necessary, check the efficiency of the hydrostatic system. |
Err 50 | Calibration is interrupted by the user with the |
Err 51 | Speed is above 0,1 km/h |
Err 52 | The engine speed is lower than 1400 rpm. |
Err 53 | The hand brake is not applied. |
Err 54 | The signal from the X8 – Bevel gear theoretical speed sensor is incorrect. |
Err 55 | The signal from the X8 – Bevel gear theoretical speed sensor is incorrect. |
Err 56 | The signal from the X25 – Engine speed sensor is incorrect. |
Err 57 | Clutch pedal sensor: The pedal is not pressed. |
Err 58 | Clutch pedal sensor is faulty. |
Err 59 | High/low speed range (Hare/Tortoise) shift switch has been activated. |
Err 60 | High/low speed range (Hare/Tortoise) shift switch is faulty. |
Err 61 | High/low speed range (Hare/Tortoise) shift switch has been activated. |
Err 62 | High/low speed range (Hare/Tortoise) shift switch is faulty. |
Err 63 | The range position sensor is not in neutral due to the calibration of the range position sensor. |
Err 64 | Electrical fault with X11 – Solenoid valve limiting speed to 30 km/h |
Be the first to review “Challenger MT455E, MT465E, MT475E Tractor Service Manual”
You must be logged in to post a review.
Reviews
There are no reviews yet.