CAT EC25N2, EC25EN2, EC25LN2 Forklift Lift Truck Service Manual

CAT EC25N2, EC25EN2, EC25LN2 Forklift Lift Truck Service Manual

$36.50

CAT EC25N2, EC25EN2, EC25LN2 Forklift Service Manual: 417 Pages
Operation and Maintenance Manual: 189 Pages
Controller Manual: 216 Pages

Publication 99759-8N200
English
Format: PDF

 

Categories: ,

Description

Caterpillar CAT EC25N2, EC25EN2, EC25LN2 Lift Truck Manual

Lift Truck Forklift Model: EC25N2, EC25EN2, EC25LN2
Publication 99759-8N200
English
Format: PDF

CAT EC25N2, EC25EN2, EC25LN2 Forklift Service Manual: 417 Pages
Operation and Maintenance Manual: 189 Pages
Controller Manual: 216 Pages

Forklift Manual Table of Content:

  • General Information
  • Electrical System
  • Power Train
  • Motor
  • Transfer and Differential
  • Front Axle
  • Rear Axle
  • Brake System
  • Steering System
  • Hydraulic System
  • Masts and Forks
  • Service Data
  • Options

Discharge electric charges stored in the inverters by using the following procedure.
(1) Turn OFF the key switch.
(2) Disconnect the battery plug/connector.
(3) Remove the rear cover.
(4) Place a 150 Ω/25 W resistor between P and N terminals in the traction inverter to discharge electric charges stored in the inverter.
(5) After touching the resistor to the P and N terminals for approx. five seconds, measure the voltage between the terminals with a multimeter and confirm a reading of 5V or less.
(6) Perform the same procedure for the pump inverter in order to discharge electric charges from all inverters.

Check whether the resistance between + and – of the battery plug/connector on the lift truck side is 1 kΩ or more when connecting the battery plug/connector for the first time after maintenance.
Note: Discharge electric charges completely before measuring. Longer measurement time reduces resistance value.

 

1 review for CAT EC25N2, EC25EN2, EC25LN2 Forklift Lift Truck Service Manual

  1. 5 out of 5

    krsboyle (verified owner)

    Manual was accurate and very helpful. Had the correct procedures to adjust group 3 settings when battery was changed from 48V to 36V. Spot on connector pin outs and procedure to replace section of logic board.


Add a review

You've just added this product to the cart: