Description

Takeuchi TB175 and TB175W Excavator Service Manual

Type: Excavator TB175 and TB175W
Format: PDF
Language of the Manual: English

Takeuchi TB175 and TB175W Service Manual – 978 Pages and 922 Pages
Takeuchi TB070 Operating Manual – 225 Pages
Parts Manual for TB175 and TB175W – 631 Pages
Engine Manual for 4TNE98-TBZ – 111 Pages

The manual describes operation, service, repair and maintenance of the excavator, as well as safety instructions that should be follow.

The Takeuchi TB175 and TB175W manual is intended for persons who engage in maintenance operations, and explains procedures for disassembly and reassembly of the machine, check and maintenance procedures, maintenance reference values, troubleshooting and outline specifications, etc. Please use this Takeuchi manual for excavator TB175 and TB175W as a reference in service activities to improve maintenance techniques.
Please note that the contents and diagrams included in this manual may not match your machine exactly.

Items or diagram which manual contains are subject to change without notice due to design modifications, etc. Always store the Takeuchi excavator manual near at hand preferably on the machine itself. When transferring ownership of this machine, be sure to provide the owner manual to the next owner.

Table of Content of TB175 and TB175W Instructions Manual:

I . GENERAL
II . SPECIFICATIONS
III. MACHINE CONFIGURATION
IV. HYDRAULIC UNITS
V . TROUBLESHOOTING
VI. ENGINE

Before operating, perform the prescribe inspections and make repairs immediately should any irregularities be found. If a failure that causes loss of control such as steering, service brakes or engine occurs, stop the machine motion as quickly as possible, follow the shutdown procedure, and keep machine securely park until the problem is fixed.

Extract from the Service Manual:

Inspect the swivel joint.
• Disconnect the hose between the swivel joint and the counterbalance valve from the counterbalance valve side and set a pressure gauge
in the hose.
• Operate the travel lever and measure the pressure.
• The swivel joint is normal if the pressure gauge reading indicates the standard value.
Standard value: Approx. 27.5 MPa

Inspect the counterbalance valve.
• If neither forward nor reverse travel is possible, the spool (1) of the counterbalance valve could be sticking in the neutral position.
• If either forward or reverse travel is possible, the spool (1) of the counterbalance valve could be sticking in a position other than the neutral position.
• Disconnect the counterbalance valve plug (2) and try pushing the spool (1) with a finger. It is normal if it moves smoothly about 6 mm.