Description

Scania Multi Service Manual and Parts Catalog for All Models March 2021

Scania models covered by Multi system:
Scania P, G, R, S truck series (2016-)
Scania P, G, R, T seris truck (2003-)
Scania 4 Series truck (1994-2008)
Scania 3 Series truck (1987-1996)
Scania F , K , N Series Bus (2004-)
Scania 4 Series bus (1994-2010)
Scania 3 Series bus (1987-1999)
Scania 4 series engine
Scania 5 series engine
Scania E2011 (2010-)
Scani P96 (1996-)

The program SCANIA MULTI contains information on spare parts for cars and buses Scania. All information is presented since 1985, for trucks, chassis and buses of SCANIA series, for all regions (different equipment and performance). Service documentation in English and multiple other languages.

Parts Catalogue for the 3 , 4 , P , G , R, and T  series trucks as well as for 4 , K and N series buses. Workshop Manual for Scania 4, P, G, R and T series trucks as well as for 4, K and N series buses.

Instruction on how to install the software from Scania.
We will provide our own easy to follow installation guide.

Use the workshop information
The workshop information provides instructions for working methods to reduce the risk of damage and injury. Scania assumes that the workshop information is available to the mechanics and that the instructions are adhered to.
Observe warnings

The workshop information contains symbols to indicate dangerous or essential tasks. Always read and follow these warnings and instructions.
Do not make the mistake of thinking you are aware of all the risks. The properties of a part or the chemical composition of a product may have changed since you last used it.

New features in the Workshop Manual
• Electrical diagram, function description and location drawing introduced for fifth
wheel with 3 sensors. This only applies to vehicles in the L, P, G, R, S series.
• Introduction of gearbox G33CM/R
• Introduction of retarder R4700D for gearbox G33CM/R
• Introduction of new EG power take-off for gearbox G33CM/R
• Introduction of Scania’s new electric buses
• Conversion of power take-off EK730P/740F to EG730P/740F
• Work description for power take-off EG730P/740F
• Axle gear RB662 with freewheeling tandem axle
• Intro of new unit bearing for rear wheel hub H8HR/SR/H9SR
• Info on added O-rings for brake drum for rear wheel hub H8HR/SR/H9SR
• New info on lubrication for front wheel hub H7HF
• New compressed air diagrams for gearboxes
• Troubleshooting wizards for LNG (CHART and SAG); located under 03-95
Troubleshooting and symptoms – Fuel system LNG
• Check – Check valve
• Check – Refuelling
• Check – Manual gas recovery shut-off valve
• Check – Check valve assembly
• Check – Pressure control valve and its filter
• Check – Pressure build-up function
• Check – Pressure build-up circuit