Description

Massey Ferguson 6711, 6712, 6713 Tractor Manual

Model: Massey Ferguson MF 6700 Series Tractor
Format: PDF
Language: English
Publication No: ACT001919A

Massey Ferguson 6711, 6712, 6713 Tractors Workshop Manual – 1533 Pages
Parts Catalog – 474 Pages

Manual Table of Content

1 Introduction
2 Separation of assemblies
3 Engine
4. Clutch
5. Gearbox
6. Rear axle
7. Power Take Off
8. Front axle
9. Hydraulics
10. Electricity
11. Electronics
12 Operator environment

Removing the crankshaft

Procedure
1. Remove the oil sump.
2. Disconnect the lubricating oil pipe of the balancing unit from the cylinder block.
3. Loosen the fixing bolts of the balancing unit.
4. Remove the balancing unit and the lubricating oil pipe.
5. Loosen the fixing screws to remove the pressure pipe of the oil pump from the cylinder block.
6. Remove the oil pump and the suction and pressure pipes.
7. Remove the flywheel and the crankshaft rear oil seal with housing.
8. Remove the belt pulley and the hub from the crankshaft front end.
9. Remove the timing gear housing.
10. Remove the bearing caps of the connecting rod and push the connecting rods out of the way of the crankshaft.
11. Remove the main bearing caps and lift out the crankshaft.

Checking crankshaft
NOTE: When grinding, note that the journal edges must remain round.

NOTE: Because of the automatic assembly, the thrust bearings are integrated into the main bearings.
Undersize spare part main bearings and thrust bearings are always supplied separately