Description

Manitou MRT 1850, MRT 2150, MRT 2540 Euro 3 Privilege Telehandler Repair Manual

Format: PDF
Language: English
Telehandler Applicable Model:
MRT 1850 Euro 3 Privilege
MRT 2150 Euro 3 Privilege
MRT 2540 Euro 3 Privilege

• Manitou MRT 1850, MRT 2150, MRT 2540 Euro 3 Privilege Telehandler Repair Manual – 528 Pages
• Manitou Axle Type 212 Repair Manual – 266 Pages
• Mercedes Motor OM 904 LA ( 120-150-175 CV Euro 3) – 400 Pages
• Manitou RADIOCOMANDO C26-PRO Manual – 76 Pages
• Manitou Hydrostatic Pump H1 045/053/060/068 Manual – 66 Pages

Table of content of the Repair Manual:

• GENERAL
• ENGINE
• OPTION – ACCESSORIES
• TRANSMISSION
• AXLE
• BRAKE
• TELESCOPIC BOOM
• HYDRAULIC
• ELECTRICITY
• FRAME – BODY

This section contains general instructions and notes on safety for inspection and maintenance tasks.

The efficiency and continued operation of mechanical units depend on constant, correct maintenance and also on efficient repair work, should there be a break-down or malfunction. The instructions contained in this Manitou MRT 1850, MRT 2150, MRT 2540 Euro 3 Privilege Telehandler repair manual have been based on a complete overhaul of the unit. However, it is up to the mechanic to decide whether or not it is necessary to assemble only individual components, when partial repair work is needed. The manual provides a quick and sure guide which, with the use of photographs and diagrams illustrating the various phases of the operations, allows accurate work to be performed.All the information needed for correct disassembly, checks and assembly of each individual component is set out below. In order to remove the differential unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle.

INTRODUCTORY REMARKS: All the disassembled mechanical of  the MRT 1850 Euro 3 Privilege, MRT 2150 Euro 3 Privilege, MRT 2540 Euro 3 Privilege should be thoroughly cleaned with appropriate products and restored or replaced if damage, wear, cracking or seizing have occurred. In particular, thoroughly check the condition of all moving parts (bearings, gears, crown wheel and pinion, shafts) and sealing parts (o-rings, oil shields) which are subject to major stress and wear. In any case, it is advisable to replace the seals every time a component is overhauled or repaired. During assembly, the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one component requires the replacement of the other one. During assembly, the prescribed pre-loading, backlash and torque of parts must be maintained.