Description

Kubota M100X, M110X, M126X, M135X Tractor Workshop Manual

Kubota Tractor Model M100X, M110X, M126X, M135X
Publication: 9Y111-02690
Format: PDF
Language: English
Kubota M100X, M110X, M126X, M135X Tractor Workshop Manual – 690 Pages
Kubota M100X, M110X, M126X, M135X Tractor Operators Manual – 178 Pages

Additional two supplement manuals are included to cover the M126DTPC and M135X-S Tractor.

Table of Content of the Workshop Service Manual

This Workshop Manual tells the servicing personnel about the mechanism, servicing and maintenance of the M100X, M110X, M126X and M135X. It contains 4 parts: “Information”, “General”, “Mechanism” and “Servicing”.
Information
This section contains information below.
• Safety First
• Safety Label
• Specification
• Dimension
General
This section contains information below.
• Engine Identification
• Model Identification
• General Precautions
• Maintenance Check List
• Check and Maintenance
• Special Tools
Mechanism
This section contains information on the structure and the function of the unit. Before you continue with the subsequent sections, make sure that you read this section.
Refer to the latest version of Workshop Manual (Code No. 9Y021-01870 / 9Y021-18200) for the diesel engine / tractor mechanism that this workshop manual does not include.
Servicing M100X, M110X, M126X, M135X
This section contains information below.
• Troubleshooting
• Servicing Specifications
• Tightening Torques
• Checking, Disassembling and Servicing All illustrations, photographs and specifications contained in this manual are of the newest information available at the time of publication.

• When you disassemble the M100X, M110X, M126X, M135X Tractor, carefully put the parts in a clean area to make it easy to find the parts. You must install the screws, bolts and nuts in their initial position to prevent the reassembly errors.
• When it is necessary to use special tools, use KUBOTA special tools. Refer to the drawings when you make special tools that you do not use frequently.
• Before you disassemble or repair machine, make sure that you always disconnect the ground cable from the battery first.
• Remove oil and dirt from parts before you measure.
• Use only KUBOTA genuine parts for replacement to keep the machine performance and to make sure of safety.
• You must replace the gaskets and O-rings when you assemble again. Apply grease (1) to new O-rings or oil seals before you assemble.
• When you assemble the external or internal snap rings, make sure that the sharp edge (3) faces against the direction from which force (2) is applied.
• When inserting spring pins, their splits must face the direction from which a force is applied. See the figure left side.
• To prevent damage to the hydraulic system, use only specified fluid or equivalent.