Description

Komatsu D41E-6, D41P-6 Dozer Service Manual

Komatsu Dozer Bulldozer D41E-6, D41P-6 Model
Language: English
Publication: SEBM007009 and SEBD028803
Format: PDF
Komatsu D41E-6, D41P-6 Service Manual – 677 Pages
Komatsu D41E-6, D41P-6 Service Manual – 607 Pages

Table of Content of the Komatsu Dozer D41E-6, D41P-6 Manual:

01 GENERAL …………………………………………………………………… 01-1
10 STRUCTURE AND FUNCTION……………………………………..10-1
20 TESTING AND ADJUSTING…………………………………………20-1
30 DISASSEMBLY AND ASSEMBLY…………………………………30-1
40 MAINTENANCE STANDARD………………………………………..40-1
90 OTHERS …………………………………………………………………….. 90-1

This shop manual has been prepared as an aid to improve the quality of repairs by giving the serviceman an accurate understanding of the product and by showing him the correct way to perform repairs and make judgements. Make sure you understand the contents of this manual and use it to full effect at every opportunity.

This shop manual mainly contains the necessary technical information for operations performed in a service workshop. For ease of understanding, the manual is divided into the following chapters; these chapters are further divided into the each main group of components.

STRUCTURE AND FUNCTION
This section explains the structure and function of each component. It serves not only to give
an understanding of the structure, but also serves as reference material for troubleshooting.

TESTING AND ADJUSTING
This section explains checks to be made before and after performing repairs, as well as adjustments to be made at completion of the checks and repairs. Troubleshooting charts correlating “Problems” to “Causes” are also included in this section.

DISASSEMBLY AND ASSEMBLY DOZER D41E-6, D41P-6
This section explains the order to be followed when removing, installing, disassembling or assembling each component, as well as precautions to be taken for these operations.

MAINTENANCE STANDARD
This section gives the judgement standards when inspecting disassembled parts.

ADJUSTING WORK EQUIPMENT CONTROL LINKAGE AND SAFETY LEVER LINKAGE

1. Adjusting rod at control lever end

1) Adjust so that distance between pins “a” of lift spool rod (1) is the dimension below. * Dimension “a”: 96 mm 2) Adjust so that distance between pins “b” of tilt spool rod (2) is the dimension below. * Dimension “b”: 145 mm 3) Adjust so that distance between pins “c” of angle spool rod (3) is the dimension below. * Dimension “c”: 91 mm 2. Adjusting rod at spool end

1) Adjust so that distance between pins “d” of lift spool rod (4) is the dimension below. * Dimension “d”: 98 mm 2) Adjust so that distance between pins “e” of tilt spool rod (5) is the dimension below. * Dimension “e”: 104.6 mm 3) Adjust so that distance between pins “f” of angle spool rod (6) is the dimension below. * Dimension “f”: 104.6 mm 3. Adjusting safety lever rod

1) Adjust so that distance between pins “g” of safety lever (7) is the dimension below. * Dimension “g”: 345.9 mm 2) Set the safety lever in the LOCK position, and check that pin (8) enters plate (9).