Komatsu D155AX-6 Dozer Service Manual

Description

Table of Contents

00 Index and foreword
01 Specification
10 Structure, function and maintenance standard
20 Standard value table
30 Testing and adjusting
40 Troubleshooting
50 Disassembly and assembly
80 Air conditioner
90 Diagrams and drawings

00. Index and foreword
This section explains the shop manuals list, table of contents, safety, and basic information.

01. Specification
This section explains the specifications of the machine.

10. Structure, function and maintenance standard
This section explains the structure, function, and maintenance standard values of each component. The structure and function sub-section explains the structure and function of each component. It serves not only to give an understanding of the structure, but also serves as reference material for troubleshooting. The maintenance standard sub-section explains the criteria and remedies for disassembly and service.

20. Standard value table
This section explains the standard values for new machine and judgement criteria for testing, adjusting, and troubleshooting. This standard value table is used to check the standard values in testing and adjusting and to judge parts in troubleshooting.

30. Testing and adjusting
This section explains measuring instruments and measuring methods for testing and adjusting, and method of adjusting each part. The standard values and judgement criteria for testing and adjusting are explained in Testing and adjusting.

40. Troubleshooting
This section explains how to find out failed parts and how to repair them. The troubleshooting is divided by failure modes. The S mode of the troubleshooting related to the engine may be also explained in the Chassis volume and Engine volume. In this case, see the Chassis volume.

50. Disassembly and assembly
This section explains the special tools and procedures for removing, installing, disassembling, and assembling each component, as well as precautions for them. In addition, tightening torque and quantity and weight of coating material, oil, grease, and coolant necessary for the work are also explained.

80. Appendix
The section explains the equipment which can not be included in the other sections. This section explains the structure, function, testing, adjusting, and troubleshooting of the equipment.

90. Diagrams and drawings (chassis volume)/Repair and replacement of parts (engine volume)
Chassis volume
This section gives hydraulic circuit diagrams and electrical circuit diagrams.
Engine volume
This section explains the method of reproducing, repairing, and replacing parts.

Clearance limit
– Parts can be used until the clearance between them is increased to a certain limit.
The limit at which those parts cannot be used is called the “clearance limit”.
– If the clearance between the parts exceeds the clearance limit, they must be replaced or repaired.

Interference limit
– The allowable maximum interference between the hole of a part and the shaft of another part to be assembled is called the “interference limit”.
– The interference limit shows the repair limit of the part of smaller tolerance.
– If the interference between the parts exceeds the interference limit, they must be replaced or repaired.