John Deere PowerTech 8.1L Diesel Engines Technical Manual (CTM86)

Description

Table of Contents(Component Technical Manual – CTM86)

Section 01—Safety
Group 000—Safety
Section 02—Cylinder Identification
Group 001—Cylinder Identification
Section 03—Cylinder Disassembly
Group 001—100 Series Wire Lock Cylinder
Group 002—100/120 Series External Retaining Ring
Cylinder
Group 003—120 Series Spanner Nut Cylinder
Group 004—120 Series Hidden Rod Cylinder
Group 005—125 Series Cylinder
Group 006—180/185 Series Cylinder
Group 007—185R Series Cylinder
Group 008—225 Series Cylinder
Section 04—Piston Seal Replacement
Group 001—Piston Seal Replacement
Section 05—Rod Guide Seal Replacement
Group 001—Rod Guide Seal Replacement
Section 06—Position Sense Sensor Remove
and Install
Group 001—Unseat Position Sense Sensor
Group 002—Install Position Sense Sensor in Rod
Group 003—Install Position Sense Sensor in Barrel
Section 07—Cylinder Assembly
Group 001—100 Series Wire Lock Cylinder
Group 002—100/120 Series External Retaining Ring
Cylinder
Group 003—120 Series Spanner Nut Cylinder
Group 004—120 Series Hidden Rod Cylinder
Group 005—125 Series Cylinder
Group 006—180/185 Series Cylinder
Group 007—185R Series Cylinder
Group 008—225 Series Cylinder

Use this component technical manual in conjunction with the machine technical manual. An application listing in the introduction identifies engine-models/applications. See the machine technical manual for information on engine removal and installation, and gaining access to engine components.

Information is organized in sections and groups for the various components requiring service instruction. At the end of the book are summary listings of all applicable essential tools, service equipment, and other materials needed to do the job, service parts kits, specifications, wear tolerance, and torque values.
Before beginning repair on an engine, clean the engine and mount on a repair stand. (See CLEAN ENGINE in Group 010 and see MOUNT ENGINE ON REPAIR STAND in Group 010..)

This manual contains SI Metric units of measure followed immediately by the U.S. Customary units of measure.
Most hardware on these engines is metric sized.

Some components of this engine may be serviced without removing the engine from the machine. Refer to the specific machine technical manual for information on components that can be serviced without removing the engine from the machine and for engine removal and installation procedures.

Read each block of material completely before performing service to check for differences in procedures that apply to the engine model number you are working on. If only one procedure is given, that procedure applies to all the engines in the manual.

Fundamental service information is available from other sources covering basic theory of operation, fundamentals of troubleshooting, general maintenance, and basic types of failures and their causes.

This component technical manual (CTM) covers the base engine  produced in Waterloo, Iowa. This manual’s coverage includes: emissions non-certified, emissions certified Tier I, and emissions certified Tier II (esn 200,000 — ) engines. This manual is a complete revision of CTM86 (06JUL99). Replace earlier manual with the following new manuals:
• CTM86 — POWERTECH® 8.1 L Diesel Engines—Base Engine
• CTM243 — POWERTECH® 8.1 L Diesel Engines—Mechanical Fuel Systems
• CTM134 — POWERTECH® 6.8 L & 8.1 L Diesel Engines—Level 3 Electronic Fuel Systems with Bosch In-Line Pump
• CTM255 — 8.1 L Diesel Engines—Level 9 Electronic Fuel Systems with Denso In-Line Pump
• CTM68 —Electronic Fuel Injection Systems