John Deere 75, 80, 100, 175, 240, 245, 260, 265, 280 Farm Loader Technical Repair Manual (TM1298)

Description

Table of Content (Technical Manual – TM1298)

SECTION 10—INTRODUCTION AND SAFETY
INFORMATION
Group 05—Introduction Information
Group 10—Safety
Group 15—Loader/Tractor Compatibility
Group 20—Serial Numbers
Group 25—Lubricants
Group 30—Hardware Torque
SECTION 20—SPECIFICATIONS
Group 05—Loaders
Group 10—Buckets
Group 15—Cylinders
SECTION 30—BUCKETS
Group 05—Replacing Cutting Edge
Group 10—Installing Competitive Adapters
Group 15—Installing Grapple Reinforcement
Group 20—Replacing Digging Teeth
Group 25—Replacing Bucket Bushings
SECTION 40—BOOM AND MASTS
Group 05—Inspect Squareness
Group 10—Replace Boom Bushings, 200 Series
Group 15—Replace Mast Bushings, 200 Series
Group 20—Replace Bushings 146, 148 And 158Loaders
Group 25—Replace Boom Bushings, 100 and 175 Loaders
Group 30—Replace Bushings, 110 Loader
Group 35—Replace Bushings, 80 Loader
SECTION 50—MOUNTING FRAMES
Group 05—Modifying Mounting Frames
Group 10—Adjusting Mast Wedges
Group 15—Battery Box Revisions, 146 Loader On Tractor/SGB
Group 20—Tighten Tractor Hardware
Group 25—Tighten Mounting Frame Hardware
SECTION 60—CONTROLS
Group 05—Adjust Cables
Group 10—Change ICV Control Position
SECTION 70—HYDRAULIC COMPONENTS
Group 05—Independent Control Valve
Group 10—Regenerative Valve
Group 15—Relief Valve
Group 20—Self-Leveling Valve, 110 Loader
Group 25—Cylinders
Group 30—Hydraulic Connections, Independent Control Valve
SECTION 100—OPERATION AND TEST
Group 05—Hose Connection Identification
Group 10—Hydraulic Operational System
Group 15—Operational Checkout Procedure
Group 20—Diagnostic And Test Procedure