John Deere 5050E, 5060E, 5067E, 5075E FT4 (MY23-) Tractors (North America) Repair Technical Manual

Description

Table of Content
(Repair Technical Manual –  TM903919)

Section 10—General Information
Group 05—Safety
Group 10—General Specifications
Group 11—General Specifications (12×12 PR Transmission)
Group 15—Fuel and Lubricants
Group 20—Serial Number Locations
Group 25—Features and Accessories

Section 20—Engine Repair
Group 05—Engine
Group 10—Cooling System
Group 15—Troubleshooting

Section 30—Fuel, Air Intake and Exhaust Systems
Group 05—Fuel System
Group 10—Air Intake System
Group 15—Exhaust System

Section 40—Electrical Repair
Group 05—Battery, Starter and Alternator
Group 10—Electrical System Components
Group 15—Wiring Harness
Group 20—Additional Information- Troubleshooting

Section 50—Power Train Repair (12×12 PR Transmission)
Group 05—Clutch Housing
Group 10—Clutch Assembly
Group 15—Transmission
Group 21—Rear PTO
Group 26—Differential
Group 30—Final Drives
Group 35—Mechanical Front Wheel Drive

Section 51—Power Train Repair (9×3 TSS Transmission)
Group 05—Clutch Housing
Group 10—Clutch Assembly
Group 15—Transmission
Group 21—Rear PTO
Group 26—Differential
Group 30—Final Drives
Group 35—Mechanical Front Wheel Drive

Section 60—Steering and Brake Repair
Group 05—Steering Repair
Group 10—Brake Repair
Group 15—Troubleshooting

Section 70—Hydraulic Repair
Group 05—Hydraulic Pump and Filter
Group 15—JD Rockshaft
Group 25—EATON Selective Control Valve (SCV)
Group 30—Mid Mount Selective Control Valve (SCV)
Group 35—Troubleshooting
Group 40—Hydraulic Field Installation Kits (if equipped)

Section 80—Miscellaneous Repair
Group 05—Front Axle
Group 10—Wheels
Group 15—3-Point Hitch
Group 25—Hood
Group 30—Transmission Troubleshooting

Section 90—Operator Station Repair (OOS)
Group 05—Seat and Support
Group 06—Center Console
Group 10—Roll-Gard™
Group 15—Operator Platform
Group 20—Fenders
Group 25—Canopy (If Equipped)
Group 30—Additional Information- Troubleshooting

Section 91—Operator Station Repair (Cab)
Group 05—Seat and Support
Group 10—Control Console
Group 20—Cab Components
Group 30—Air Conditioning System
Group 35—Heating System

(Diagnostic Technical Manual –  TM904019)

Section 210—General Information
Group 05A—Safety
Group 05B—General References
Group 05C—Technical Specific References

Section 211—Diagnostic Trouble Codes
Group 05—General References
Group CCU-PR—CCU Code Diagnostics (PR)
Group CCU-TSS—CCU Code Diagnostics (TSS)
Group ECU—ECU Code Diagnostics
Group EIC—EIC Code Diagnostics
Group ICC-PR—ICC Code Diagnostics (PR)
Group ICC-TSS—ICC Code Diagnostics (TSS)
Group PTR—PTR Code Diagnostics

Section 212—Observable Symptoms
Group 05—General References
Group 20—Engine System
Group 30—Fuel, Air Intake, Exhaust, and Cooling System
Group 40—Electrical System
Group 45—Electronic Control Unit System
Group 50—Drive System and Transmission System
Group 60—Steering System
Group 61—Brakes System
Group 70—Hydraulic System
Group 90—Cab-Open Operator’s Station System

Section 213—System Diagnostics
Group 05—General References
Group 40—Electrical System Diagnostics
Group 45—Electronic Control Unit Diagnostics
Group 50—Drive System and Transmission System Diagnostics
Group 60—Steering System Diagnostics
Group 61—Brakes System Diagnostics
Group 70—Hydraulic System Diagnostics
Group 90—Cab-Open Operator’s Station System Diagnostics

Section 220—Engine Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Tests and Adjustments

Section 230—Fuel, Air Intake, Exhaust, and Cooling Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information

Section 240A—Electrical General and Theory of Operation
Group 05—General References
Group 20—Electrical Theory of Operation

Section 240B—Electrical Schematics
Group 05—General References
Group 30AA—Starting and Charging (OOS)
Group 30AB—Starting and Charging (Cab)
Group 30BA—Lighting System (OOS)
Group 30BB—Lighting System (Cab)
Group 30CA—Instrument Cluster Control (OOS)
Group 30CB—Instrument Cluster Control (Cab)
Group 30DA—Horn, Service Advisor, and Trailer interface (OOS)
Group 30DB—Horn, Service Advisor, and Trailer interface (Cab)
Group 30EA—Windshield Wiper and Radio (Cab)
Group 30FA—Seat and Backup Alarm (OOS)
Group 30FB—Seat and Backup Alarm (Cab)
Group 30GA—Transmission and MECA 2-51 Controller (OOS)
Group 30GB—Transmission and MECA 2-51 Controller (Cab)
Group 30HA—Engine Controller and Air Heater (OOS)
Group 30HB—Engine Controller and Air Heater (Cab)
Group 30IA—Kits (OOS)
Group 30IB—Kits (Cab)
Group 30JA—MTG Control Unit (OOS)
Group 30JB—MTG Control Unit (Cab)
Group 30KA—EQRL Control Unit (Cab)
Group 30LA—CAN and Ground Citcuit (OOS)
Group 30LB—CAN and Ground Citcuit (Cab)
Group 30MA—Heat Ventilation and Air Conditioning (Cab)
Group 30NA—Power Outlet and Lighter (Cab)

Section 240C—Electrical Components and Connectors
Group 05—General References
Group 40A—Electrical Assemblies, Modules, and Control Units
Group 40B—Sensors
Group 40C—Resistors-Condensors-Capacitors
Group 40D—Memory and Binary Devices
Group 40E—Lights
Group 40F—Fuses
Group 40G—Charging System
Group 40H—Monitoring-Warning Devices
Group 40K—Relays
Group 40M—Motors
Group 40S—Switches
Group 40V—Diodes
Group 40W—Wiring Harnesses
Group 40X—Interconnects (OOS)
Group 40XA—Interconnects (Cab)
Group 40Y—Solenoids and Electrically Actuated Mechanical Devices
Group 40Z—Ground Points (OOS)
Group 40ZA—Ground Points (CAB)

Section 240D—Electrical Tests and Adjustments
Group 05—General References
Group 50—Tests and Adjustments

Section 245—Electronic Control Units
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 40—Component and Connector Information
Group 50—Test and Adjustments
Group CCU-PR —Chassis Control Unit (CCU-PR)
Group CCU-TSS—Chassis Control Unit (CCU-TSS)
Group ICC-PR—Instrument Cluster Control (ICC-PR)
Group ICC-TSS—Instrument Cluster Control (ICC-TSS)
Group PTR—Power Train Reverser Control Unit

Section 250—Drive Systems and Transmission Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Test and Adjustments

Section 260—Brakes Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Tests and Adjustments

Section 261—Steering Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Test and Adjustments

Section 270—Hydraulics Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Tests and Adjustments

Section 290—Cab-Open Operators Station Operation, Test, and Adjustments
Group 05—General References
Group 10—Calibrations, Preliminary Checks and Operational Checks
Group 20—Theory of Operation
Group 30—Schematics
Group 40—Component and Connector Information
Group 50—Tests and Adjustments

Section 299—Special Tools
Group 05—General References
Group 10—Service Tools
Group 15—Dealer-Fabricated Tools