Description

Hitachi ZW310-5A, ZW310-5B Wheel Loader Service Manual

The manual is applicable for the Hitachi ZW310-5A, ZW310-5B Wheel Loader Model

Format: PDF
Language: English
Service Manual consists of the following:

For Model ZW310-5A as mentioned above:

Troubleshooting Manual: Vol. No.TTNFC-EN (411 Pages)
Operation Manual : Vol. No.TONFC-EN (455 Pages)
Circuit diagram: 18 Pages

For Model ZW310-5B as mentioned above:

Troubleshooting Manual: Vol. No.TTNFA-EN (432 Pages)
Operation Manual : Vol. No.TONFA-EN (447 Pages)
Circuit diagram: 17 Pages

Table of Content of the Technical Manual
SECTION 4 OPERATIONAL
PERFORMANCE TEST
Group 1 Introduction
Group 2 Standard
Group 3 Engine Test
Group 4 Machine Performance Test
Group 5 Component Test
Group 6 Adjustments
SECTION 5 TROUBLESHOOTING
Group 1 Diagnosing Procedure
Group 2 Monitor
Group 3 e-Service
Group 4 Component Layout
Group 5 Troubleshooting A
Group 6 Troubleshooting B
Group 7 Air Conditioner

Table of Content of the Operation Manual

SECTION 1 GENERAL
Group 1 Specifications
Group 2 Component Layout
Group 3 Component Specifications
SECTION 2 SYSTEM
Group 1 Controller
Group 2 Control System
Group 3 ECM System
Group 4 Hydraulic System
Group 5 Electrical System
SECTION 3 COMPONENT OPERATION
Group 1 Pump Device
Group 2 Control Valve
Group 3 Cooling Fan System
Group 4 Steering Pilot Valve
Group 5 Steering Valve
Group 6 Pilot Valve
Group 7 Charging Circuit
Group 8 Drive Unit
Group 9 Axle
Group 10 Brake Valve
Group 11 Others

Hitachi ZAXIS ZW310-5A, ZW310-5B service manual consists of the Troubleshooting and the Workshop Manual.

• Information included in the Service Manual: Technical information needed for redelivery and delivery, operation and activation of all devices and systems, operational performance tests, and troubleshooting procedures.
• Information included in the Workshop Manual: Technical information needed for maintenance and repair of the machine, tools and devices needed for maintenance and repair, maintenance standards, and removal / installation and assemble / disassemble procedures.

Muffler Filter Regenerative Control
The muffler filter regenerative control burns PM which deposits in filter (CSF) (5) by using the exhaust gas and removes it. This is Regeneration. The regeneration of the muffler filter consists of own regeneration and mandatory regeneration. The mandatory regeneration consists of auto regeneration and manual regeneration. (Refer to SYSTEM / Control System.)

Own Regeneration
1. The own regeneration regenerates by using the high-temperature-exhaust gas without the diesel oxidation catalyst (DOC) (6) function.
2. A catalyst is activated in case the exhaust temperature of the inlet of filter (5) is higher. Then, regeneration amount increases.