Description

Hino Truck 2015 COE HEV Service Manual

This is the Repair and Service Manual for Hino Truck 2015 COE HEV
Applicable for HINO 155, 155h, 195, 195h series,
Format: PDF
Language: English

Hino 2015 COE HEV Truck Manual for 155, 155h, 195, 195h Series – 842 Pages
Hino 2015 COE HEV Owners Manual – 338 Pages
Troubleshooting Hino 2015 Manual – 860 Pages
Hino J05E Engine Manual – 647 Pages

This workshop manual has been prepared to provide information covering repairs on 155, 155h, 195, 195h Series Hino 2015 COE HEV trucks.

To use Hino Year 2015 and Series 155, 155h, 195, 195h Conventional trucks for years, smoothly, safely, and economically without trouble, it is important to perform inspections.
Maintenance required to be performed is the responsibility of the owner. Some recommended repairs of your truck are mentioned. When making any repair of your truck, be careful not to be injured through improper procedures.

As for maintenance items, refer to the Owners and Drivers Manual. All information and specifications in this manual are based upon the latest product information available at the time of printing.

Table of Content For Hino 2015 COE HEV Truck Manual:

General Introduction
Engine
Hybrid System
Transmission
Clutch
Propeller Shaft
Axle
Differential
Brake
Steering
Frame and Frame Accessory
Cab Mounting and Cab Suspension
Body Construction
Suspension
Body Inside Accessory
Body Outside Accessory
Air Bag and Seat Belt
Heater and Air Conditioner
Electrical
Control System

Hino Truck 2015 COE HEV Manual Instruction Extract:

INSTALLING THE DISC BRAKE
1. INSTALLING THE BLEEDER PLUG CAP
2. TEMPORARILY TIGHTENING THE BLEEDER PLUG 3. INSTALLING THE PISTON SEAL
(1) Apply lithium soap base glycol grease to the entire circumference of the new piston seal and install it to the groove of the brake caliper.
4. INSTALLING THE PISTON
(1) Apply lithium soap base glycol grease to the new disc caliper boots (2 pcs.).
(2) Install the cylinder boots to the groove of the piston.
! CAUTION Install the cylinder boots securely to the groove of the piston.
(3) Apply lithium soap base glycol grease thinly to the piston circumference and install it to the disc caliper.
! CAUTION Do not forcefully push the piston in.
5. INSTALLING THE DISC CALIPER BOOT
(1) Install the disc caliper boots (2 pcs.) to the disc caliper.
! CAUTION Install the cylinder boot securely to the groove of the disc caliper.