Description

Doosan DX340LC-5 and DX350LC-5 Excavator Service Manual

Doosan Excavator DX340LC-5 and DX350LC-5
Format: PDF
Language: English
Publication No: 950106-01001E
Serial Number: 10001 and Up

Doosan DX340LC-5 and DX350LC-5 Excavator Service Manual – 1631 Pages

How to Use The Doosan DX340LC-5 and DX350LC-5 Excavator Guide Manual:

This manual provides information for servicing the DX340LC-5 and DX350LC-5 Doosan Excavator. All service procedures are broken down into detailed steps, listed in their recommended sequence. The manual uses both photographs and drawings to help locate and itemize components. The table of Contents on the preceding pages is your best tool for finding the service procedure you need. Be certain to observe all Safety information included in these pages.

A schematic of each of the major engine systems is provided at the beginning of the section of the manual devoted to troubleshooting and repairing that particular system.

Basic safety precautions are list in the Safety section of the Doosan DX340LC-5 and DX350LC-5 Excavator Service Manual. Additional safety precautions are list in the Safety section of the owner/operation/maintenance publication. Specific safety warnings for all these publications are provided in the description of operations where hazards exist. WARNING labels have also been put on the product to provide instructions and to identify specific hazards.

DOOSAN DX340LC-5 and DX350LC-5 Instruction Table of Content:

Track Excavator Maintenance Safety
Specifications
General Maintenance Instructions
Standard Torques
Engine
Engine Coolant Heater (Option)
Cabin
Counterweight
Hydraulic Oil Tank
Fuel Tank
Main Pump
Drive Coupling (Main Pump)
Main Control Valve
Swing Device
Fan Pump for Oil Cooler
Fan Motor for Oil Cooler
Gear Pump (Rotation)
Joystick Valve (Work Lever)
Travel Control Valve (with Damper)
Solenoid Valve
Accumulator
Two Pump
Swing Bearing
Center Joint
Travel Device
Track Assembly

Doosan DX340LC-5 and DX350LC-5 Manual Instruction Extract:

Power Take-off

Procedure

To seal the cover of the power take-off.
1. Remove two attaching screws (2) of the cover (1) with an Allen key (WAF 10).

2. Turn the cover 45 and pull off the cover.

3. Remove old O-ring (3) and replace it with a new one.

 

Inspect the case and the groove.

4. Insert the new O-ring in the recess in the cover and install the cover.

5. Tighten the attaching screws (2) according to the specifications in chapter

Precaution on page 41.