Description

Challenger MT425B, MT445B, MT455B Tractor Repair Workshop Manual

Manual for: AGCO Challenger MT400B Series Tractor
Format: PDF
Published Number: 3378609M5
English
Issued October 2007

Challenger Tractor MT425B, MT445B, MT455B Workshop Manual : 1971 Pages
Technician Service Book MT400B series tractors manual: 209 Pages
MT400B series tractors: Supplement to version M5 of October 2007: 622 Pages
Parts Catalog: 637 Pages

Challenger MT400B Series Manual TABLE OF CONTENTS

01 – Introduction – Specifications
02 – Splitting the tractor
03 – Engine
04- Clutch
05 – Gearbox
06 – Rear axle
07 – Power take off
08 – Front axle
09 – Hydraulics
10 – Electrical equipment
11 – Electronics
12 – Cab and equipment

The Challenger Tractor Manual Preface & General

The purpose of this manual for challenger MT425B, MT445B, MT455B is to assist customers in the efficient installation, maintenance and repair of Challenger equipment. Carrying out the procedures as detailed, together with the use of special tools where appropriate, will enable the operations to be completed within the time stated in the repair time schedule.

Structure of the manual

Page numbering
This manual is divided into chapters and sections, each page containing the following information: Example: 10A12.1
10 = chapter
A12 = section
1 = page number within the section The issue number is indicated at the bottom of the page.
Summaries
For quick reference, each chapter starts with a table of contents, listing the various sections included in that chapter.
Meaning of references
(. .. ): identification of parts and components Amendments
Modified pages will be edited using the same page numbering as the preceding pages-only the issue number changes.
The old pages should be destroyed.

When parts have to be replaced, it is essential that only genuine Challenger parts are used.
The following points are of particular importance when carrying out repairs and fitting replacement parts and accessories.
Tractor safety may be compromised if non-genuine parts are fitted.

Legislation in certain countries prohibits the fitting of parts that do not comply with the tractor manufacturer’s specifications. Torque wrench setting figures given in the workshop manual must be strictly adhered to. Locking devices must be fitted where specified. If the efficiency of a locking device is impaired during removal, it must be replaced.