Case STX275, STX325, STX375, STX425, STX450, STX500 Steiger Tractor Service Manual

Description

Table of Contents

General
Engine
Electrical
Steering
Power Train
Brakes
Hydraulics
Chassis
Air Conditioning
Controller Fault Codes
Electrical Schematic
Hydraulic Schematic

Manual Extract: INSTRUMENTATION PROGRAMMING

General Information
The standard instrumentation controller must be configured/calibrated before any other controller. Tractor Standard instrumentation programming is performed through three levels. At the first level, operation setup permits adjustment of display units and tire radius. At the second level, controller configuration permits viewing of the current selection for tractor model (set during third level) and configuration of the electronic controllers that are expected to be on the TDB (Tractor Data Bus). The third level requires the use of the service tool to select the tractor model and fuel tank size.

IMPORTANT: All three levels of programming must be performed when moving an instrumentation controller from one tractor to another.

NOTE: When replacing the standard instrumentation controller the fuel tank size selection must be selected using the service tool configuration window.