Case MW24C Wheel Loader Service Manual

Description

Table of Contents

• Introduction
• Mw24c Loader Maintenance
• Troubleshooting
• Engine, Fuel, Exhaust And Cooling Maintenance
• Electrical System
• Power Train
• Brake System
• Wheel And Steering
• Frame And Towing Attachments And Body And Cab
• Accessory Item And Data Plates
• Hydraulics System
• Signaling Devices And Loader Bucket

Manual Extract: HYDRAULIC SYSTEM OIL TOO HOT

Step 1. (Cont).
a. If operator is not moving control levers completely into power position, instruct him to do so.
b. If operator is moving control levers completely into power position, go to step 2 below.

Step 2. Check hydraulic oil for contamination.
Take a sample of hydraulic oil and check if it is dark and thick, has an odor of burned oil, particles of metal or dirt in oil, or appears that water is in oil.

If any of the above is seen, oil is contaminated.
a. If oil is contaminated, drain hydraulic system and clean strainer (page 11-79), and replace oil filters (pages 8-40 and 11-82).
b. If oil is not contaminated, notify next higher maintenance level (additional checks must be performed).