Case 9060B Excavator Service Manual

Description

Table of Contents

1. Specification
2. Maintenance
3. System
4. Disassembling
5. Troubleshooting
6. Engine
7. Installation Procedures for Optional Attachments

Manual Extract Arm Cylinder

NOTE: The numbers in parentheses;; in the following steps refer to the Arm Cylinder illustration on page 38.
1. Install the clamp (13} on the cylinder and secure with the cap screw ( 11) and washer ( 12). Tighten the cap screw to 25 lb-ft (32 Nm).
2. Install the hydraulic tubes (5) in the clamp (9) and secure the clamp with the lock washer (8) and cap screw (7).
Tighten the cap screw to 31 lb-.ft (51 Nm).
3. Install two new 0-rings (6) on the cylinder. Connect the two tubes (5) to the cylinder and secure with eight socket head cap screws (4). Tighten the cap screws to 72 lb-ft (92 Nm).
4. Install a new 0-ring (3) in the end of the tube. Install the plug (2) in the end of the tube. Tighten the plug to 176 lb-ft (226 Nm).
5. Install the lubrication fitting (1) in the cylinder.