Case 570N EP Wheel Loader Service Manual

Description

Table of Contents

• Content
• Introduction
• Engine
• Transmission
• Front Axle
• Rear Axle
• Power Take Off (PTO)
• Hydraulic System
• Hydraulic System
• Wheels
• Cab climate control
• Electrical System
• Front Loader and Bucket
• Platform, Cab, Bodywork and Decals
• Electrical Schematic
• Hydraulic Schematic

Manual Extract: Transmission drive and driven shafts – Disassemble Primary shaft

1. Put the primary shaft on the bench so that the end with the bearing attached is up. Remove the snap ring.

2. Install a bearing separator under the gear as shown.
DO NOT install the bearing separator between the gear and the bearing. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use moly disulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing from the primary shaft.

3. Remove the bearing.

4. Remove the thrust washer.
5. Install a bearing separator under the lip of the bearing race as shown. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use moly disulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing race from the primary shaft.