Case 350, 400, 450, 600 Steiger Tractor Service Manual

Description

Table of Contents

• Content
• Introduction
• Engine
• Transmission
• Front Axle System
• Rear Axle System
• Power Take Off (PTO)
• Brakes and Controls
• Hydraulic Systems
• Hitches, drawbars and implement couplings
• Frames and ballasting
• Steering
• Wheels
• Tracks and Suspension
• Cab Climate Control
• Electrical System
• Platform, cab, bodywork and decals
• Special Tool Index

Manual Extract: Receiver/Dryer – Static description

The receiver/drier orientation is critical. Make sure the outlet flange is within 5 ° of true level (the decal should face up).
The receiver/drier must be installed with the inlet connected to the hose from the condenser and the outlet connected to the hose going to the thermal expansion valve.

The receiver/drier is normally the last item replaced when servicing the system, just before the system is evacuated.
This prevents saturating the drier with moisture.
When servicing the receiver/drier, use the two hand, two wrench method to prevent damage to the tubes and fittings when you loosen or tighten the tube connections.
Always install new O-rings when the receiver/drier is connected to the system. Lubricate the O-rings with clean mineral oil prior to installation.