Case SR130, SR160 SkidSteer Service Manual

Description

Table of Contents

1. Contents
2. Introduction
3. Engine
4. Front Axle System
5. Rear Axle System
6. Hydrostatic Drive
7. Brakes and Controls
8. Hydraulic Systems
9. Frames and Ballasting
10. Wheels
11. Cab Climate Control
12. Electrical System
13. Front Loader and Bucket
14. Platform, Cab, Bodywork and Decals
15. Specials Tool Index

Manual Extract: Locking Instrument Panel

If a lock code has been entered; immediately after shutting off the engine the display will show lock? and the AUX OVERRIDE button will flash. Anti-theft is set by pressing the AUX OVERRIDE button. The panel is now locked and LOCKED is displayed.

Restarting requires entering the code. If the AUX OVERRIDE button is not pressed, the machine can be started without a code. The panel does not automatically lock. If a lock code has not been entered; when the engine is shut off the display will not show “ lock?” and the engine can be started without a code until a lock code is entered.

Unlocking the instrument panel
1. Sit in the seat to power the instrument panel. The warning lamps will illuminate and there will be an audible beep.
2. Press the flashing POWER button (5). The display (1) will show unloc.
3. Enter code by using multiple presses of the START button (2), AUX OVERRIDE button (4), and OPERATE button (3) . Press the POWER button (5) to save each digit and move to the next.

NOTE: For numbers 1, 2, 3 use the START button.
For numbers 4, 5, 6 use the AUX OVERRIDE button.
For numbers 7, 8, 9, 0 use the OPERATE button.
4. Press the POWER button (5) after the fifth digit to enter the code. The engine preheat lamp will illuminate and the display (1) will begin the thirty second countdown.

NOTE: If the incorrect code is entered, ERROR is displayed, followed by 00000 prompting the operator to
enter the correct code.