Description

AGCO DT205B, DT225B, DT250B, DT275B, DT300B Tractor Manual

Manual for: AGCO DTb Tractor
Format: PDF
Book Number: 4346275M3
English
Issued June 2011

AGCO DT205B, DT225B, DT250B, DT275B, DT300B Tractor Manual : 2630 Pages
AGCO DTb series tractors Technical Manual : 312 Pages
Spicer Axle Manual: 126 Pages

 Manual TABLE OF CONTENTS

Introduction
Separation of assemblies
Engine
Clutch
Gearbox
Rear Axle
Power Take off
Front Axle
Hydraulics
Electrical
Electronics
Cab
Accessories
Service Tools

DT205B, DT225B, DT250B, DT275B, DT300B Manual Extract

General
This calibration allows improved precision of forward speed depending on: – the different tyre sizes available – radar (if fitted)
Procedure
1. Mark out a 100 m (328 ft) (depending on the unit of measurement selected) on a firm surface.
2. Start up the tractor, and then press and hold the display selector switch (A) for 15 seconds.
NOTE: The daily hourmeter resets to 0 after 5 seconds.
3. “CAL” should appear on the screen
4. Drive the tractor forwards at normal working speed.

NOTE: The tractor must always be moving before starting out on the measured course; otherwise calibration will be incorrect.
5. Press the display selector switch when crossing the starting line of the 100 m (328 ft) course.
6. “run” should appear on the screen.
7. Press the display selector switch when crossing the finish line of the course.
8. Press the display selector switch; the constant forward speed (theoretical) measured during calibration is displayed.
9. Press the display selector switch again; the actual constant forward speed (radar) measured during calibration is displayed on tractors fitted with radar.
10. Press the display selector switch a final time to return the instrument panel to normal operating mode.