Case 580, 590, Super M and Super M Plus Series 3 Backhoe Manual

$34.00

Case 580, 590, Super M and Super M Plus Loader Service Manual  – 1467 Pages

Publication Number: 87728449NA
English
Revised March 2008
Format: PDF

Categories: ,
View cart

Description

Case 580, 590, Super M and Super M Plus Backhoe Loader Manual

Loader Model: 580 Super M, 580 Super M Plus, 590 Super M and 590 Super M Plus Series 3
Publication Number: 87728449NA
English
Revised March 2008
Format: PDF

Case 580, 590, Super M and Super M Plus Loader Service Manual  – 1467 Pages

Manual Table of Content:

  • General
  • Engine
  • Fuel System
  • Electrical
  • Steering
  • Power Train
  • Brakes
  • Hydraulic System
  • Mounted Equipment
  • Electrical Schematics
  • Hydraulic Schematics

Manual Extract: Load Sense Relief Valve Pressure Check

1. Park the machine on a level surface. Put the backhoe in the transport position and lower the loader bucket to the floor.
2. Stop the engine, turn on the ignition switch and pilot control switch, operate pilot controls and loader controls to relieve any pressure in the system.
3. Connect a pressure gauge with a capacity of at least 345 bar (5000 psi) to the “M” port, use adapter 101792A1, on the backhoe valve, see page 16.
4. The oil must be at operating temperature. To heat the oil, do the following steps: A. With the engine running at full throttle, hold the loader control lever in the ROLLBACK position for 15 seconds.
B. Put the loader control lever in the NEUTRAL position for 15 seconds.
C. Repeat steps A and B until the temperature of the oil is 125°F (51°C) or the side of the reservoir is very warm.
5. Start and run the engine at high idle, hold a stabilizer over relief, record the reading.
6. Compare the reading with the specifications on page 3.
7. If the pressure setting is not correct, adjust the load sense relief valve.

Reviews

There are no reviews yet.


Be the first to review “Case 580, 590, Super M and Super M Plus Series 3 Backhoe Manual”