Case 580, 590, 695 Super R Backhoe Loader Service Manual

$34.00

Case 580, 590, 695 Super R Loader Service Manual  – 1022 Pages

Publication Number: 87570830A
English
Format: PDF

Categories: ,
View cart

Description

Case 580, 590, 695 Super R Backhoe Loader Manual

Loader Model: 580 Super R, 590 Super R, 695 Super R
Publication Number: 87570830A
English
Format: PDF

Case 580, 590, 695 Super R Loader Service Manual  – 1022 Pages

Manual Table of Content:

  • Safety Precautions
  • Maintenance
  • Technical Specification
  • Torque Coverters
  • Transmission
  • Front Axles
  • Rear Axle
  • Brake System
  • Hydraulic System
  • Chassis
  • Steering
  • Cab, Heating and Air conditioning
  • Electrical System
  • Loader
  • Backhoe

Manual Extract: FAULT FINDING


1. Incorrect installation / defective axle
Correct installation or repair or replace the differential in case it does not survive any one of the test phases.

2. Overloading / incorrect weight distribution
Remove excessive weight and redistribute load, following instructions related to the vehicle.
3. Different rotation radius of the tyres
If one tyre has a smaller radius, it will cause partial wheel slipping when force is applied. The other tyre with bigger radius will have to support all the work. Replace the tyre or adjust pressure to have same radius on both tyre.

4. Broken half shaft
It is not advisable to operate the vehicle with a broken half shaft. It is acceptable to move the vehicle (engine off unloaded) a few metres away only.

5. Bent half shaft
Replace half shaft.
6. Blocked differential
Abnormal functioning of the differential or breakage/blockage of command device. Verify assembly and all components.
Vehicles with wide steering angle may proceed with kicks, have steering difficulty or cause pneumatic wearing at sharp turns. Reduce the steering angle to minimum and decelerate when the vehicle begins to kick.

7. Incorrect wheel adjustment
Verify group integrity and wheel side bearings.
Adjusting according.
8. Spoiled or worn out axle parts
Check the condition of ring gear, pinion gear, bearings etc.
Replace whenever necessary.
9. Contamination in the axle box or incorrect assembly of parts Look for foreign particles. Check assembly of the various parts of the axle.
10. Incorrect adjustment of bevel gear set: Parts of the transmission worn out. (transmission gears, U joints, etc.)
Replace or adjust as required.

Reviews

There are no reviews yet.


Be the first to review “Case 580, 590, 695 Super R Backhoe Loader Service Manual”