Case 570N EP Wheel Loader Service Manual

$35.00

Case 570N EP Loader Service Manual  – 1928 Pages

Publication Number: 47821917
1st edition English
April 2015
Format: PDF

Categories: ,
View cart

Description

Case 570N EP Wheel Loader Manual

Loader Model: 570N EP
Publication Number: 47821917
1st edition English
April 2015
Format: PDF

Case 570N EP Loader Service Manual  – 1928 Pages

Manual Table of Content:

  • Content
  • Introduction
  • Engine
  • Transmission
  • Front Axle
  • Rear Axle
  • Power Take Off (PTO)
  • Hydraulic System
  • Hydraulic System
  • Wheels
  • Cab climate control
  • Electrical System
  • Front Loader and Bucket
  • Plateform, Cab, Bodywork and Decals
  • Electrical Schematic
  • Hydraulic Schematic

Manual Extract: Transmission drive and driven shafts – Disassemble Primary shaft

1. Put the primary shaft on the bench so that the end with the bearing attached is up. Remove the snap ring.

2. Install a bearing separator under the gear as shown.
DO NOT install the bearing separator between the gear and the bearing. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use molydisulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing from the primary shaft.

3. Remove the bearing.

4. Remove the thrust washer.
5. Install a bearing separator under the lip of the bearing race as shown. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use molydisulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing race from the primary shaft.

Reviews

There are no reviews yet.


Be the first to review “Case 570N EP Wheel Loader Service Manual”